How to keep heat in the bedroom and prevent it from escaping?
Language
Helske

How to keep heat in the bedroom and prevent it from escaping?

The problem with heating and keeping the heat in the bedroom is most often related to its location in the apartment. If at least one bedroom wall is a perimeter (facade) wall, or if the bedroom features thermal bridges, windows, or balcony doors, there may be a heat leak somewhere.

To prevent rapid heat loss, reduce heating time and ensure a comfortable room climate, apply the active building material Nano Coat System.

The special material developed using modern nanotechnology helps maintain a stable room temperature. The material creates a thermo- reflective layer that reflects heat back into the room while removing excess moisture. It actively regulates the climate and distributes the heat throughout the room. It also eliminates cold places on the walls. Thanks to these properties, the material shortens the heating time and saves energy.




On which parts of the bedroom should the material be applied?

Apply Nano Coat System behind the radiators to keep the heat in the room and prevent it from escaping through the walls You can apply the Nano Coat System to all room walls, including the ceiling, sunction, in the vicinity of the windows and balconies, as the largest heat loss and condensation of the water vapor happen there, to all peripheral (facade, exterior) walls or to places where thermal bridges are located.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.


Apply in the following order: 

 1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM