How to Maintain Heat and Prevent its Escape in Rooms Adjacent to a Cellar?
Language
Helske

How to Maintain Heat and Prevent its Escape in Rooms Adjacent to a Cellar?

Cellars are colder than the other parts of the house and, as a consequence, the other areas of the house near the cellar may also become colder in autumn and winter. Heat may escape in these rooms through the common walls, through the ceiling, through thermal bridges and through the reveals of the door.

If you want to prevent rapid heat loss, shorten the heating time, and achieve a pleasant climate in the room, apply the Nano Coat System active building material.

This special mixture, developed with state-of-the-art nanotechnology, helps maintain a stable temperature in rooms adjacent to a cellar. The material creates a thermal reflective layer which reflects thermal radiation back to the room whil removing excessive moisture. It actively regulates the air and distributes it all over the room. Also, it eliminates the cold spots on the walls. Thanks to these features, it reduces heating time and saves energy.



Which Places Should the Material be Applied to in the Room?

Apply the Nano Coat System especially to the walls adjacent to the cellar, to the reveals around the door, and to the ceiling of the cellar. Also behind the radiators to reflect the heat back to the room and prevent its escape through the walls as vapour.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM