How to Speed Up the Occasional Heating of the Garage with Nano Coat System
Language
Helske

How to Speed Up the Occasional Heating of the Garage with Nano Coat System

Garage areas are often used also as workshops by do-it-yourselfers. If the garage is not heated for a long time and it suddenly needs to be heated up to room temperature, heating takes time and consumes a lot of energy. If you want to reduce the heating time and save energy, think preventively and treat your walls with the Nano Coat System active substance.

The Nano Coat System material was specially developed by the Helske company based on the principle of nanotechnologies. It creates a thermal reflective layer on the walls which reflects thermal radiation back to the room. This reduces the required heating time. In addition, if you apply the building material to the places behind the heater or radiator, you can save even more because of the reflection of the heat. Heat usually escapes through these problematic places - the walls are heated in vain. In this way, combined with proper insulation, you can save even 35% on energy annually, with respect to heating as well as cooling.

At the same time, the Nano Coat System is an efficient form of anti-mould prevention. It is designed to permeate moisture, reducing the risk of the formation of moulds and the development of allergies. You can create a lasting ideal microclimate in the garage quite simply and at no great expense.



Which Places Should the Material be Applied to in the Garage?

Apply the Nano Coat System behind all the heaters or radiators to reflect the heat back to the room and prevent its escape through the walls. Apply it also around the garage door because these are the places where
heat escapes and water vapours condense, which can be prevented with the Nano Coat System. Apply it also to all the circumferential walls (façade, external walls) or to the places where thermal bridges are present. One of the advantages of the system is that it can be applied to non- absorbent surfaces as well, such as wall tiles, floor tiles, marble, glass etc. In this way, you can apply it even to inaccessible places and to the corners of the room, often affected by moulds.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Home the final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.



 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM