Mold in bedroom – how to get rid of mold in corners?
Language
Helske

Mold in bedroom – how to get rid of mold in corners?

The source of mold in the bedroom is thermal bridges - places where the heat penetrates faster from the indoor environment to the outdoor environment compared to the other places or structures. Thermal bridges include, for example, corners and above-door structures. Water vaporises at these places much more often than at other places, the temperature of these places is usually much lower, resulting in the formation of mold.

To avoid the formation of mold in the corners of the bedroom, it is necessary to eliminate these thermal bridges. The active building material Nano Coat System can help you with that.

Thanks to the latest nanostructured technology, we have developed a building material with features that eliminate thermal bridges and reduce dampness in the bedroom. The material also prevents water vapor condensation on the surface and reduces heat loss. Creates a thermo- reflective layer on the walls that reflects the heat radiation back into the room, but excess moisture is removed to reduce the risk of mold formation.



On which parts of the bedroom should the material be applied?

Apply Nano Coat System to places where thermal bridges are located, around the windows and balcony doors. The material prevents water vapor condensation on the surfaces.

If your walls are already infested by mold, it is important first to get rid of it and repair the wall construction, and only then apply the material.
 

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM